5.0 k

Show Description
Close Description

The 5.0kw competition series amplifier is a 5,000 watt mono block. It is capable of running up to 18 volts for up to 7,300 watts. It is a linkable amp and designed to run a 1 ohm per amp or 2 ohms when strapped.

It comes with a bass knob and a clipping indicator. For power inputs it will accept dual 0 awg for power and dual 0 awg for ground.

Show Specs
Close Specs
Output Power (RMS)4 ohm14.4V900Wx1
2 ohm14.4V2,300x1
1 ohm14.4V5,000Wx1
1 ohm16V6,000Wx1
1 ohm18V7,300Wx1
Input Sensitivity 6V~0.2V
Low Pass FilterSwitchable
( @ 24 dB Slope)VariableHz35~250
Subsonic FilterSwitchable
( @ 24 dB Slope)VariableHz10~50
Bass BoostVariabledB0-9dB
Frequency Response Hz15-270
Signal to Noise Ratio dB100
Damping factor 150<
Efficiency @ 4ohm %Over 90%
THD @ 4ohmsLess than 0.1%
Fuse Rating500 Amps
Linked Fuse Rating1,000 Amps
Clip Yes
Speaker & Power terminalMold Type Yes
Heatsink Length25.59" (650mm)
Heatsink Width9.38" (238mm)
Heatsink Height2.35" (59.6mm)

Key Features

• 1 ohm stable

• Variable low pass filter

• Variable subsonic filter

• Variable bass boost

• Wired remote control

• Clipping indicator

• Dual 0 awg power and ground inputs (both must be used)

We recommend for installation

• 1 upgraded battery under the hood

• 1 extra 800ci battery in the rear

• Minimum of two 0 awg ran from the front battery to the rear battery

• Both 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 4 runs into the amp

• Upgraded aftermarket alternator

• Dash mounted voltage meter

Wc Car Audio
Droppin Hz
Sky High
Audio Intensity
SSA Audio
Showtime Electronics
Sonics Electronics
© DC Audio 2016