DC Audio “Pitbull” 20k
Amplifier Description
The Pitbull 20k competition series amplifier is a 20,000 watt mono block. It is built for 12 volt audio systems. It will not operate on 16 or 18 volt systems. It’s built with the best of the Best parts from the Mosfets to the Large Tiffany Jacks.
It comes with a bass knob and a clipping indicator. For power inputs it will accept triple 0 awg for power and triple 0 awg for ground.
Output Power (RMS)
4 ohm 5000Wx1 @ 14.4 Volts
2 ohm 7500Wx1 @ 14.4 Volts
1 ohm mono 20,000x1 @ 14.4 Volts
DO NOT CHARGE OVER 15.5Volts
Key Features
• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired Bass Knob remote control W/ Clip Light
• RCA Pass Thru
• Triple 0 Awg Power Ground Inputs
Recommended for installation
2 Upgraded Alternators or 450 amps of charging power
Upgraded under hood Battery
2000ah of AGM Batteries in the trunk or 240ah Lithium
Dash mounted voltage meter
0 Awg OFC power and ground
Power & ground runs from front to back batteries.
DO NOT mount to subwoofer box. (will void warranty)
AMP SPECS:
| DC Amp Model: | Pitbull 20k |
|---|---|
| Input Sensitivity | 6V~0.2V |
| Frequency Response | 15Hz~270Hz |
| 24dB / Octave Crossover | YES |
| Low Pass | 35Hz ~ 250Hz |
| Subsonic Filter | 10Hz-50hz |
| Bass Boost @45hz | 0 ~ 9db |
| Phase Shift | 0 ~ 180 |
| Remote Control | Yes |
| Clip Indicator | Yes |
| Signal to Noise Ratio | dB100 |
| Damping Factor | 150< |
| THD @ 4ohms | Less than 0.1% |
| Fuse Rating | External 660 amp x 3 |
| LED Status Lights | Power and Protect |
| Master/Slave | No |
| Heatsink Length | 37.75"/958mm |
| Heatsink Width | 11.5"/292mm |
| Heatsink Height | 2.6"/66mm |
Overview Video
Check out what the 20.0k Amplifier from DC Audio is all about
Customer Installs
